In a message dated 8/2/01 11:38:07 AM, Daniel1312 writes:
<< So, do I have a steel wheel axle that has been shortened or a wire wheel
axle that has had both bearing mounting sections replaced, OR does axle width
and BMC quality control vary by an eighth of an inch, possibly three
sixteenths and does it matter (it might matter to me). >>
Daniel
Most likely 1/8" across a 46" axle is an acceptable manufacturing tolerance.
I know, a couple of days ago I told someone (Jeff, I think) that 1" across
that same axle is not acceptable. It still isn't.
Bob
Annice & Bob
1960 Bugeye (Mk. IV in disguise)
1966 Sprite Mk. III (Still in Boxes)
|