Apologies for being a PITA and dumbo here but I have just bought a used wire
wheel axle casing and want to check it is correct before I build it up.
So, what is the exact width of the axle casing tip to tip in inches or metric?
Also did the width every vary by say a quarter inch over the years?
Finally, anyone ever seen a steel wheel axled 'cut n' shut to a wire wheel
width?
Thanks
Daniel1312
In a message dated 31/07/01 14:48:03 Pacific Daylight Time,
Ankitterer@aol.com writes:
<< In a message dated 7/31/01 9:32:08 AM, clabaw@jpl.nasa.gov writes:
<< Does this mean that a set-up using a disc wheel axle with w/w adapters
will
have 1" wider track? >>
Yes, the track will be 1" wider. There will also be 1/2" less axle going
into the differential, which might not be such a good deal.
|