BIg Bill-
Further on my prior response:
Didn't read last part of your message; you
are applying a 40DCOE to a 1275!!
OK:
Settings recommended by Vizard for
40DCOE on 1275 with "flowed" head
(only 1275 shown under 40DCOE but
good guide?)
Choke 35
Main 145
Air 180
Em. Tube F16
Pump 45
Idle 50F2
NOTE: No 40DCOE for any series "A"
engine shows any other emulsion
tube other than F16.
No 45DCOE for any series "A"
engine shows any other emulsion
tube other than F2 as a primary
or F9 as a secondary choice.
No 1275 application for either
carb. shows a smaller idle jet than
a "50", and in all cases the primary
air corrector to the idle system is
almost always "2" except for "full
race", which is "11".
Hope this gets you on your way!
Capt. Bob
' 61:{)
|