| To: | Robert Duquette <RobertDuquette@Sympatico.ca> |
|---|---|
| Subject: | Re: dang !!! |
| Date: | Thu, 28 Jun 2001 22:54:28 -0400 |
| Cc: | Spridgets list <spridgets@autox.team.net> |
| Organization: | Positive Earth Drivers Club |
| References: | <07da01c10041$f9171bc0$2e5ee640@bobhost.Sympatico.ca> |
Robert Duquette wrote: > > I just attempted to install my new clutch MC. Bench bled real nice. Bolted > right in without dropping the nuts more than twice. Go to connect the pipe > to it and voila, a non-fit. The fastener on the pipe is too big for the MC > opening. It unscrews, this fitting is for the larger (later) lines, early lines should screw right into the casting without the adaptor. 3/16" pipe - 1/4" pipe -- Frank Clarici Toms River, NJ Lots of Sprites http://www.exit109.com/~spritenut |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: short ( relatively no LBC, but a picture of one ), Unknown |
|---|---|
| Next by Date: | Re: dang !!!, Unknown |
| Previous by Thread: | dang !!!, Unknown |
| Next by Thread: | Re: dang !!!, Unknown |
| Indexes: | [Date] [Thread] [Top] [All Lists] |