I too had much trouble bleeding my clutch a couple of
months ago. I pumped at least a quart of fluid thru
the freaking system and nothing. Also tried all of the
other tricks mentined here in other messages. I
borrowed a mightyvac and it was bled and working in
literally 5 minutes.
John Holliday
--- Maclean Mike <macleans@earthlink.net> wrote:
> Did mine with a MityVac vacuum pump. Got the bleed
> screw finger tight and
> rotated it with the clear plastic line to open for
> vacuum pressure. Build the
> pressure in the MityVac and then open the bleed
> screw. Close off the bleed screw
> finger tight with the plastic tubung and build
> pressure in the MityVac again.
> After about 5-10 minutes of this the line was bled.
> When finished, tightened the
> bleed screw. (be careful and never overtighten a
> bleed screw. Make sure the
> master does not run out of brake fluid while doing
> this process. The pump can
> pull a lot of fluid through the system (and air
> bubbles).
> Mike MacLean Supercharged 60 Sprite
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo.com/
|