Have done this on a bugeye with rad in place and without loosening
the motor mounts. Next time the rad comes out.
Mike L
60A,67E,59Bug
----- Original Message -----
From Kent J. Miller <Bushwacker4 at prodigy.net>
To: Spridgets <spridgets@autox.team.net>
Sent: May 27, 2001 3:04 PM
Subject: Fw: crankshaft pulley clearance
> Loosen the motor mounts, jack it up a little in the front and it
can be
> done. Keep some bandaids close by for the knuckle scrapes!
Remove the
> radiator though for easier access...
>
> Kent
> 1960 Bugeye
>
>
> Subject: crankshaft pulley clearance
>
>
> > Hello everyone,
> >
> > Is it possible to remove the crankshaft pulley (and timing
cover) with
> > the engine in situ? There appears to be less than an inch of
clearance
> > between pulley and crossmember... I guess using a socket on
the pulley
> > bolt is out of the question?
> >
> > Evangelos Makris
> > 66 Sprite Mk3
|