Rob 'somebody-other-than-me" in Colehill, Dorset had some made up by cutting
and welding the ends on with the suitable amount cut out. (Member of MASC
in late 80's) Sticks in my memory because the ends had been welded back
onto the first one at 180 degrees out, leaving the brake adjuster at the top
if you put the backplates on the same way that they were originally. The
flange the backplate bolts onto is not symmetrical. Nice undamaged Minor
ends on Sprite casings. Geometrically straight and obviously the correct
track for W/W frogeyes etc.
----- Original Message -----
From <Daniel1312 at aol.com>
To: <dougi@home.com>; <spridgets@autox.team.net>
Sent: 24 April 2001 19:26
Subject: Re: Wire wheel rear axle available
> Must be rare or a special?
>
> Daniel1312
>
> In a message dated 23/04/01 20:35:01 Pacific Daylight Time, dougi@home.com
> writes:
>
> << I have a line on a quarter elliptic wire wheel rear end >>
///
/// (If they are dupes, this trailer may also catch them.)
|