In a message dated 4/23/2001 1:23:31 PM Eastern Daylight Time,
Daniel1312@aol.com writes:
> This is one of the more diffcult tasks on a Spridget. When I last did this
> I
> think it was on my own but it helps if there are 2 people. I always have
> some way/person pushing the clutch push rod back up into the slave as hard
> as
> possible when bleeding. I forget what spanner I used but it would have
> been
> nothing flash (pre Snap-on days for me).
>
>
There is a way to screw a fitting into the bleeder hole in the clutch master
and run brake pipe up into the engine compartment, then thread the pipe and
screw in a bleeder. That way the clutch can be bled from under the bonnet. I
don't remember the exact fittings or pipe sizes, but it sounded like a
sterling idea.
--David C.
///
/// (If they are dupes, this trailer may also catch them.)
|