>I drilled out the hole a 64th of an inch at a time up to final size of
29/64ths. I only used light pressure to cut through >the axle. The drill
bits were only high speed steel, nothing exotic. I used motor oil as cutting
oil to lubricate the bit. >Cutting oil is much better, but I did not have
any. This process was tedious but worked.
Try WD-40 It will help cool the bit as well as lubricate and you can apply
as you drill.
Paul Van Wig
Long Beach, CA
60 Bugeye
60 Minor Woody
61 Minor Pickup
01 Dodge Cummins Ram
///
/// (If they are dupes, this trailer may also catch them.)
|