Rob,
Seems that only one would work with the front cover plate you have. There
must be two different covers with the pivot in a slightly different
location. Otherwise the TO bearing won't be centered properly on the first
motion shaft. A LHD Morris has the release arm on the left while a Sprite
has it on the right on both RHD and LHD. I'm guessing that a RHD Morris has
it on the right... right? Maybe that's the difference?
Gerard
At 5:07 PM +0000 3/24/01, rob thomas wrote:
>I've been converting a Minor release arm to use on my wife's car when it
>gets the hydraulic clutch. Problem is that I have since found a different
>Midget-type arm that is the same length as the one I took off my Sprite but
>has the pivot drilling at a different position, thus giving a different
>length between the pivot and the point where the pushrod pin sits.
>Obviously this also means there is a different length between the pivot and
>the centre of the carbon release bearing.
>
>Any ideas which one is correct and what the other one came off of? Neither
>has a fully legible part number. One shows 2A ????, the other is nearly
>blank.
>
--
Please visit Four Points Travel -
Discount Online International Travel Reservations
http://www.gerardsgarage.com/fourpoints
To make a reservation please call Toll Free 1-800-272-3253
G G Gerard Chateauvieux
E A
R R pixelsmith@gerardsgarage.com
A A
R G Pixelsmith on Duty
D E
S http://www.gerardsgarage.com
///
/// (If they are dupes, this trailer may also catch them.)
|