Re: A Lathe, any good?

All,

I know there is a wealth of knowledge in this group that I would like to tap 
on the subject of lathes.  Would someone care to go to this site and look at 
the Emco 10 inch (V10P) with the milling setup as well as several chucks that 
I can 
get used...>:

http://www.lathes.co.uk/emco/page4.html

Is this unit any good?  What should I pay if it is in good condition?  What 
should I be cautious about?  It does not have the British screw set, but has 
the book, etc.

I am going to look at it today, any help is appreciated.

Thanks, John Carey (CA)