Ulix, et. al,
I played with this a bit and think I found a suitable switch.
Beck/Arnley number 201-1158.
85/80 c or on @185 / off @ 176 f 5/8-18 thread single wire. Note that on
Spridgets the sealing is done at the bevel of the sensor seating. It's a
gland nut. This sensor has a step which very closely approximates the bevel
of the original. It fits almost all Chrysley/ Mitsubishi imports 84-91 4
cylinder. Sells for $30. ish.
I have not actually tried to install it or use it, but it should do.
HTH Peter C.
----
At 12:13 PM 8/17/2000, ulix wrote:
>I have an electric fan now (the cheap 11" Tripac fan, fits perfectly)
>and would like to find a thermostat that screws into the existing
>fitting on the downflow rad. (thread size 5/8-18)
>
>Has anyone found one that fits and has a turn-on temp that's about right?
>Any other solutions?
>
>Thanks, Ulix
>
>P.S. my car runs and drives, but some issues need to be worked out,
>report later
|