David Brackman wrote:
>
> Hi list,
> Can someone please explain further lowering the rear of 1/4 eliptic
> cars? I know a spacer is required under the spring, but what about the
> locating hole?. I did try the archives but they werent too clear on
> this,
David
A wedge the same width as the leaf stuck under the bottom leaf will
lower it.
I found a square shaped "U" bolt from a boat trailer to clamp the wedge
to the leafs. I used the small leaf from and old set as a shim, anything
1.5" wide and about 1/4" thick will work but find a clamp so it does not
bounce out.
--
Frank Clarici
Toms River, NJ
If you are not living on the edge,
You're taking up too much space!
http://www.exit109.com/~spritenut
|