Just curious what causes there are for head gaskets blowing. Timing is
correct. Head has been shaved and is not warped. 1500 engine, .020 over
with higher compression (Victoria British) pistons, Victoria British
standard gasket. What could be causing the head gasket to keep blowing?
Bad head bolts? Crappy gasket? Compression too high? Block need to be
decked? Just trying to go through the process of elimination. Can the top
of the block warp just sitting around (it was checked a few years ago by a
machine shop and was fine then)? Thanks!
adrian
-------------------------------------------
J. Adrian Barnes
adrian@workgroup.net
http://www.choosebig.com
http://www.midgetweb.com
-------------------------------------------
|