Gerard:
It wasn't the bracket that broke - it was the valve cover stud. My design
priority was to avoid lifting the entire weight of the engine and
transmission with two relatively small head studs. Now I attach one bracket
to the manifold studs on one side and to the two bolts on the rear
generator bracket. They attachment points are strong and numerous and the
brackets are as well. To each his own, but IWFM.
At 11:02 PM 04/17/2000 -0700, Gerard Chateauvieux wrote:
>I think probably the easiest, safest, strongest home made bracket for
>lifting the engine is the "C" channel stock plumbers use to anchor pipe to
>walls in new construction. I can't remember the correct name, but it has
>spaced holes (sometimes round, sometimes oval) which easily adapts to the
>valve cover bolts. A large eyebolt in the center makes a good place to hook
>your come-along.
>
>Gerard
>
>At 1:01 PM -0400 4/17/00, Bob Spruck wrote:
>>Brad:
>>I have used the stock lifting brackets numerous times until one of the
>>valve cover studs broke on me. We were putting the eng/trans back in the
>>vintage race car after a winter rebuild. I had replaced the stock head
>>studs with the ARP "strengthened" ones. As we got the engine at the right
>>angle to get the trans to clear the battery shelf, the ARP stud broke,
>>sending the engine/trans crashing. The oil pan hit the valence panel
>>forward of the radiator and the rear seal of the trans hit the concrete
>>floor. Nobody's fingers or toes were in the way thankfully. Ever since
>>then, I have used a two piece bracket set I fabricated. One is an 18" long
>>2"x2" angle iron that attaches to the manifold studs (all six of them) with
>>another piece welded to it to allow the chain attachment. The second piece
>>goes onto the rear generator mount on the block (two bolts) or to the front
>>generator mount on the water pump.
>>I got real paranoid about lifting that much weight that high after that
>>experience. Since the engine goes in and out of the race car more often
>>than the one in a street car, I eventually invested $199 in an engine hoist
>>from Sam's Club that has more than paid for itself in ease of use and
>>safety. I can now remove or install the engine by myself. I still keep all
>>parts of my body clear. Once you drop an engine, you get real safety
>>conscious.
>>
>>
>>
>>At 08:16 AM 04/15/2000 -0500, Brad Fornal wrote:
>>>I was digging through my parts boxes and found one of the engine lifting
>>>brackets as shown in the OS&M page 41 (top of the left photo). Does
>>>anyone have another one that they would part with? With some of the
>>>engine work I have coming up it would be handy to have two of them and
>>>BTW exactly where are they supposed to bolt onto, anyone know?? Brad
>>Regards,
>>
>>Bob Spruck
>>Sharpsburg, GA
>>' 67 Midget Vintage Racer
>>' '72 Midget Weekend Car
>>4 parts cars in the woods
>
>
>
>
>G G Gerard Chateauvieux
> E A
> R R pixelsmith@gerardsgarage.com
> A A
> R G Pixelsmith on Duty
> D E
> S http://www.gerardsgarage.com
>
>
>
>
>
Regards,
Bob Spruck
Sharpsburg, GA
' 67 Midget Vintage Racer
' '72 Midget Weekend Car
4 parts cars in the woods
|