To: | ulix@u.washington.edu, spridgets@autox.team.net |
---|---|
Subject: | Re: Reinstalling the engine |
From: | Daniel1312@aol.com |
Date: | Fri, 3 Dec 1999 17:09:44 EST |
Reply-to: | Daniel1312@aol.com |
Sender: | owner-spridgets@autox.team.net |
Ulix, You are right that you would need to lift up the engine (and dent the bit that gets dented beneath the heater case) to get the pulley on again and it would also be difficult to get it torqued up. Unless anyone has a different experience that is. Daniel In a message dated 02/12/99 15:30:55 Pacific Standard Time, ulix@u.washington.edu writes: << Would it help to leave the crank pulley off and install it afterwards? Or would that not help because the engine would have to be lifted up so high to install the pulley that it would be stuck again? >> |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Vizardz A series, R. Toby Atwater |
---|---|
Next by Date: | Re: resurrection/test drive, Daniel1312 |
Previous by Thread: | Re: Reinstalling the engine, Jeff Boatright |
Next by Thread: | Re: Reinstalling the engine, Wiedemeyer |
Indexes: | [Date] [Thread] [Top] [All Lists] |