wizardz wrote:
>
> Use a pencil eraser as the abrasive to clean all electrical contacts.
> It's the equivalent of 3000 grit sandpaper and will leave a very bright shine
>on the metal
> and makes it very easy to get down in the switch to clean them.
> Just remember to clean out all the eraser shavings that rub off and
I find the some of the contacts are hard to reach with a pencil eraser.
You can get the eraser to the contacts, but you cannot really rub the
contact. My solution for this is to take a brand new pencil and break it
off so that eraser side is about 4-5 inches long. Then place the pencil in a
variable speed drill and you had a cleaning surface that spins like a champ.
You will have the contact clean in a heartbeat.
Bill Gilroy
77 Midget
90 Shar-Pei
|