There is also a tiny hole cutter that drills around the spot weld that is
great to use. The use of an air chisel or anything else that deforms the
metal isn't needed then. Available at body and auto paint supply houses.
Paul
PAsgeirsson@juno.com
On Tue, 16 Nov 1999 22:35:54 EST Lancer7676@aol.com writes:
>In a message dated 11/16/99 10:33:39 PM Eastern Standard Time,
>dms@snip.net
>writes:
>
><< I was wondering if there is a good way of detaching the welds on
>the side
>rails
> or sills without causing too much damage? >>
>
>Yes there is, Michael. I did so by first drilling out the spot welds,
>then
>separating them with an air hammer chisel, then grinding the inner
>rocker
>smooth. It worked pretty well.
>
>--David C.
|