There was a prior thread (Hi Jay) about air/fuel ratio monitor's and I was
wondering if anybody ever installed one.
I'm going to install one if I have to pull the engine to solve my current
clutch problem.
The question is, has anyone used the one made by Edelbrock? The cost is
$126.00 and I believe it is the heated type. The display unit uses a series
of lights running from Yellow to Red so it looks like it could be used to
tune a carb for economy without getting it too lean.
For those who offered advice on the clutch problem, I slowly pressed the
clutch while trying to put the tranny in gear. At the point where it would
go into gear, the engine would also bog down. This says that a shorter
pushrod will not help. Any other ideas that I can try without pulling the
engine?
Thanks,
Larry Miller
http://www.ado13.com
God, grant me the Senility to forget the people I never liked anyway,
The good fortune to run into the ones that I do,
And the eyesight to tell the difference.
|