Hi Charles,
The problem of clouding at the edges of safety glass is usually the
result of the soft inner layer of plastic/adhesive absorbing water.
Unfortunately, it's not reversable, short of new glass.
About an inexpensive engine stand, Costco sells one for less than $50
that is more than adequate. It also rotates.
Regards, Paul
PAsgeirsson@juno.com
On Fri, 12 Nov 1999 11:09:16 -0500 "Charles D. Sorkin"
<cdsorkin@ix.netcom.com> writes:
>Good Morning List:
>
>I understand that this problem is typical on most windshield glass of
>MG
>vintage. The edges around the rubber seals have developed a white
>cloudy
>haze. Is there any sort of product that one could use to polish it
>out?
>
>Also, could anyone recommend a retailer of a cheap, sturdy engine
>stand that
>allows for turning the engine (not just holding it upright)? Doesn't
>need
>to be big, it only has to hold a 1275. New or used, doesn't matter.
>
>
>Regards,
>
>Charles
>'74 Midget
>cdsorkin@ix.netcom.com
>Bloomfield, NJ
>
|