But, for a BH 100-4 the bearing for the same place is a 02474 cone and the
same cup 02420. Perhaps the pinion shaft could be modified for the more
available and cheaper Healey bearing. I haven't time to research the size
differences... anyone?
Peter C
---
At 01:17 PM 10/28/1999 , Bkitterer@aol.com wrote:
>Found both parts locally but the price for the cone is even higher, $186.
>The cup is $7.18. I can get them for a little less but still is expensive.
>
>Bob (and Annice)
>
>In a message dated 10/27/99 5:20:21 PM, nosimport@mailbag.com writes:
>
><< Clint,
> Tough one.... Timken part numbers 02477 cone and 02420 cup (outer race)
>Cup readily available.
>Cone...... Timken quoted my cost $151.13 and 16 weeks to make. Maybe
>someone out there has better connections. I suspect MM and M don't see a
>market.
> Made a few calls and found some NOS ones. I'll contact you off-list.
>Peter C
>---
>At 10:24 AM 10/27/1999 , Clint Bergst wrote:
>>In checking on bearings for my Bugeye's differential, it seems that
>>noone has the rear-inner bearing (tried MiniMania and Moss). The side
>>and front bearings are readily available.
>>
>>Anyone know of a supplier for the rear-inner bearing? Or, is it easy to
>>find the later carrier to raplace my OE unit?
>>
>>TIA
>>
>>Clint >>
|