rear brakecylinder holder-on'rs

["shawn tobin" <suhs2@hotmail.com>]

Anybody got a source for the curved washers that go under the circlips that 
hold on the brake cylinders that push on the shoes that rub on the drums 
that bolt to the hubs that connect to the tires that stop the car that I 
built?

The washer seems to be 11/16" id and 1" od and is curved and .030" thick.  
The circlips are for a 11/16" shaft and fit in a groove that is .646" diam 
and about .040" thick.

McMaster-Carr skips over that size curved washer but has the circlips at 
$13/100.