Herb,
When I converted my sprite from + to - ground, the only thing that I needed to
swap wires on was the coil. ( I did the conversion to use the ignitor
electronic
ingnition). The wipers, heater blower, and starter, didn't care about the
polarity change, and still all run in the same direction ( I tested these out).
The tech notes on the web were pretty straight forward, and everything worked
like a champ when I was done.
regards - Bryan Vandiver (59-bugeye)
>X-Accept-Language: en
>MIME-Version: 1.0
>To: spidgets <spridgets@autox.team.net>
>Subject: Ground
>
>Fellow Spridgeteers,
>
>In the tech articles regarding converting from positive to negative
>ground, I've not seen mentioned anything about the starter. It is a DC
>motor and the bendix is specifically designed...right!?!
>
>WFO Herb
>Keep the sticky side down.
>
|