Just a "We Tight" tip. For polishing the little bores use a pencil and a strip
of
emory cloth (crocus?) Just duct tape the strip to the end of the pencil and wrap
the rest around the pencil. You can even use a drill to hurry things along. As
you
polish and the paper gets clogged just tear off the clogged part and continue.
Don't use a drill bit....Takes a bit longer than a hone, but it works!
Bruce Lowry
Ajhsys@aol.com wrote:
> In a message dated 10/5/99 3:09:38 PM Eastern Daylight Time,
> bruce@woodward-realty.com writes:
>
> << I found a 3/4" hone at NAPA, states is for VW brake cylinder. worked on my
> dual master cylinder perfectly. >>
>
> - - - - - - - - - - - - - - - - - - - - - - - -
>
> I was talking about the clutch MC, which is smaller. And I wasn't about to
> buy a whole bunch of hones to try to get the right size, so I just bought a
> new MC. I'm sure somebody makes the right hone.
>
> Allen Hefner
> SCCA Philly Region Rally Steward
> '77 Midget
> '92 Mitsubishi Expo LRV Sport
|