To: | Lancer7676@aol.com |
---|---|
Subject: | Re: bad cylindar |
From: | HFC <froggi@cdsnet.net> |
Date: | Sun, 03 Oct 1999 21:57:45 -0700 |
Cc: | Midget02885@aol.com, spridgets@autox.team.net |
Organization: | WFO Racing |
References: | <30e4ab24.2524978d@aol.com> |
Reply-to: | HFC <froggi@cdsnet.net> |
Sender: | owner-spridgets@autox.team.net |
Buy a leak-down tester! WFO Herb Keep the sticky side down! Lancer7676@aol.com wrote: > In a message dated 9/29/99 8:58:33 PM Eastern Daylight Time, > Midget02885@aol.com writes: > > << # 4 cylindar is not responding.. > switched to new plugs, new wires, new distributor cap and rotor. > >> > > Take off the valve cover and check the valves and the valve train. Could be > the intake valve isnt opening for some reason, not allowing gas into the > piston. > > --David |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Alternator/Water Pump Update, David Riker |
---|---|
Next by Date: | Re: Sprite rear hub seal solution tech tip, Wm. Severin Thompson |
Previous by Thread: | spridget tops, Herb_Goede |
Next by Thread: | Spridget logo, R. Toby Atwater |
Indexes: | [Date] [Thread] [Top] [All Lists] |