There is no down side that I have found to bolts, except they will probably
deduct points at the concours judging. When you get it apart thread a stud
back lightly, put the housing back on and thread on a nut then screw out the
stud and then use a bolt slightly shorter than the length of the stud.
Regards,
Peter.
In a message dated 7/7/99 6:25:18 PM Eastern Daylight Time, tzuchow@ibm.net
writes:
> Is there any downside to using bolts on the thermostat housing? If and when
> I ever manage to break my housing loose, I might do bolts if there is no
> reason not to do so.
>
|