The pressure from the nut keeps the plate from spinning, there should not be
a spacer.
Regards,
Peter.
In a message dated 7/1/99 11:16:05 PM Eastern Daylight Time, Jpp963@AOL.COM
writes:
> Took the generator pulley and fan plate off to clean and paint. Upon
> reassembly I noticed the fan plate doesn't engage ( sits below) the key on
> the shaft. Seems there needs to be a spacer between the plate and the
split
>
> collar which sits inside the end plate. If so, what is its composition?
> Generator is a C40 model. Manuals (I did check, Jay :>) ) were of no help.
>
|