| To: | Bob Chamberlain <bobchamb@southwind.net> |
|---|---|
| Subject: | Re: RH-LH |
| From: | HFC <froggi@cdsnet.net> |
| Date: | Wed, 02 Jun 1999 21:59:40 -0700 |
| Cc: | spridgets@autox.team.net |
| Organization: | WFO Racing |
| References: | <3.0.1.16.19990530183402.2fafb564@pop.southwind.net> |
| Reply-to: | HFC <froggi@cdsnet.net> |
| Sender: | owner-spridgets@autox.team.net |
Yes! WFO Herb Bob Chamberlain wrote: > A quick question,-------When I refer to right hand threads on a nut or > bolt, I mean that it tightens by turning clockwise.Left hand threads would > tighten by turning counter clockwise. Is this everyones understanding also? > If this is the case, then my wire wheel knockoffs are right handed on > the left hand side of the car, (viewed from driver's seat) and left handed > on the right hand side of the car. Next question. Are the axle nuts > "handed" too? |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: U-Joints, HFC |
|---|---|
| Next by Date: | Message count!, HFC |
| Previous by Thread: | Re: hub nut tool?, HFC |
| Next by Thread: | Message count!, HFC |
| Indexes: | [Date] [Thread] [Top] [All Lists] |