Hi,
I don't know if anyone has answered your question yet, but the standard
filter for the downdraft weber on a spridget is about 1" high. I've
purchased mine from the "B" Hive in Clemson, SC. (1-800-652-4483) because
they have a table at a lot of the local car shows. I just pick em up at the
shows. I'm sure you could get one from anyone of the usual suppliers.
Robert
http://www.woozy.com/midget
At 6:41 PM -0400 4/19/99, ERIC080@aol.com wrote:
>question:
>
>I've got a problem with the new filter of the down draft weber carb. It does
>not make clearance of the bonnet (hood)!
>
>I can use thinner gasket but still too high, any suggestions, the current
>filter is about 1.5 inches high, touching on front right corner (1500 engine).
>
>Does someone sell a one inch filter to lower the head alittle?
>
>Eric
>77 midget
|