Can someone describe how the Bugeye Door pockets are constructed. My
car never had any panels when I purchased it so I bought the Moss panel
kit.
I picked up a couple of doors from Carlisle (no reason to but cheap) and
one of the doors had the panel on it. Had a curved metal top strip,
masonite backing, cardboard cutout on top of masonite to make a recess,
covered with vinyl, and rivited to the door (4 places). Is this the
correct configuration?
Second question - if the above is correct why are there two pieces of
foam rubber the approximate shape of the door panel included with the
kit - where do these go?
Thanks,
Bob Frato
ahbugeye.com
-got the rebuilt engine w/rear seal and tranny back finally just need to
paint, put together and install and figure out how to time an engine all
by May 2.
|