Hi All!
Probably gonna be pulling the engine this weekend to do some more work and
cleanup a few leaks. When the engine was last pulled, we simply ran chain
around the engine and connected the chain to a hoist. Putting it back in,
we very carefully ran chain around the engine since it was just painted.
Now that I'm pulling it again, I'd like to find a better way.
Most of the advice is to tie the chain to the head/rocker studs(no chain
knots, but using an metal angle). Can these studs take the weight?? Since
I have an LCB header, this comes off before I pull the engine, so I don't
have a manifold to hook onto, either.
Suggestions??
Jason.
| Jason Urban - APOGEE LABS 215-699-2060 |
| CA Studio www.dynanet.com/~crackerarts |
| '95 Z/28 6spd '65&'67 Austin-Healey Sprites |
|