Crash,
APT is where I got all my engine parts from. I made a note that I
can get the offset keys from MM in 1 degree increments. I didn't spring
for ARP fasteners, I'm running out of money on this $2k rebuild. I think I
would use ARP for rod and main cap hardware before I would spend the money
on head studs. If a head stud breaks you need a new headgasket, rods or
mains can cost the whole engine.
What kind of engine are you building?
Thanks for the info,
Ulix
On Fri, 19 Feb 1999, David Ramsey wrote:
> Ulix, I got my offset cam keys today from APT, they come in 2, 4, 6,
> and 8 deg offset and as one tooth is 16 deg (don't even ask how I
> know) you should be able to get it within 2 deg no matter what is is
> now. Also got the ARP Head stud kit # HSA9 which includes all the
> studs, washers, and 12 point nuts for the head and rockers for $99.80.
> I'm working on another source for the same kit for $83.69 but they
> were back ordered. APT also sent some flyers ( lots of racing stuff)
> with the order, I'll have to check out when I get my cam done Advanced
> Performance Technology 595 Iowa Avenue - Suite C Riverside, CA 92507
> 1-800-278-3278 909-686-2831/fax www.aptfast.com
> Crash
>
Ulix __/__,__ ___/__|\__
..............................................(_o____o_)....<_O_____O_/...
'67 Sprite '74 X1/9
|