Rather than using a reamer, have the bushings honed at your local auto
machine shop. If you don't have a press to put in the new bushings, just
take the swivel axles, swivel pins and bushings in and have them do the
whole bit of fitting the bushings. Usually only a few dollars and it's
beautiful when completed.
Paul
PAsgeirsson@juno.com
On Sun, 29 Nov 1998 11:43:39 -0800 "Gary Barker" <gbarker@citynet.net>
writes:
>I was going through the Moss Catalog and was ordeing 4 trunnion
>bushings.
>At the bottom of the page, there was a note that you needed a reamer
>tool in
>order to install thies bushes. The cheapest I've found this tool in
>for
>$199.00. I don't want to pay this amount for a tool I'll probably
>just use
>for this one time instilation. My questionis: Is there a way to fit
>these
>bushings without this tool? And if so, how do you do it? I
>appreciate any
>help in this.
>
>Thanks, Gary
>
>
|