You may or may not recall that I asked about a noisy PCV valve about a week
ago. Nobody had any good ideas, but thinking about it gave me another
question:
What is the proper crankcase venting? My 1275 has a PO-installed aftermarket
valve cover with a 1/2-inch hose fitting. I am using that 1/2-inch hole
(fitted with a small filter) for the vent. But I have a steel valve cover in
the parts box that I got with the car and it is blanked off where that hose
fitting is.
Should I block off the hose fitting on my valve cover?
Thanks to all who answer. I really appreciate the help I get from this list.
Tom Zuchowski
'61 Bugeye
Clemmons, NC
|