To: | "'spridgets@autox.team.net'" <spridgets@Autox.Team.Net> |
---|---|
Subject: | floor panels & crossmember |
From: | "BOLIN, TIMOTHY" <TBOLIN@scana.com> |
Date: | Sat, 30 May 1998 21:54:19 -0400 |
Reply-to: | "BOLIN, TIMOTHY" <TBOLIN@scana.com> |
Sender: | owner-spridgets@Autox.Team.Net |
i'm finally ready to weld in replacement floor panels in my 65 midget, i also will be fitting in new sections of the cross member. should i : a. leave the original crossmembers in place while i weld up the panels then cut them out b. cut them out, then weld the panels in followed by the crossmembers c. cut the crossmembers out, weld the new sections in then weld up the floor panels would appreciate any insight thanks tim |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | velocity stacks and wheels, Vllas |
---|---|
Next by Date: | Horn Blows....., Frank Clarici |
Previous by Thread: | velocity stacks and wheels, Vllas |
Next by Thread: | Horn Blows....., Frank Clarici |
Indexes: | [Date] [Thread] [Top] [All Lists] |