Frank and list,
OK I replaced the universals - that cured the grinding and clunking.
The anti roll bar was pitifully loose - fixed that.....
The right front damper seems a little worn, I filled it with oil and it
got a little better but not quite right - Is there anything else I
should try or am I better off putting on another?
I find that the rear springs need bushes at both ends - are there
choices here? Rubber? Poly? Nylon?
There is a very very slight amount of play in the front bearings. Is
this normal or could the races be a little worn?
The front bushes seem solid, but they are old and look a bit dried out I
figure I should replace them while I am doing the rear bushes. What is
best here and where do I get them?
Drivers side floor pan needs replacing also, (I have had some panels
that did not fit very well), I would like to get the replacement panel
that "FITS" for the floor pan where is the best place to get the best
panels? Or should I just make one up myself?
Thanks,
Kevin
|