Daryl May wrote:
> Sorry if this is a repeat, but I think my similar message got lost.
>
> I want to install a conventional oil cooler off a 1967 Midget onto my
> Bugeye.
>
> 1. The Bugeye hood is not available right now. Does anyone know if I am
> going to have a fit problem? The cooler is about 5 inches high and would
> go in the same place as on the Midget, which is on a purpose-made bracket
> that spans the two longitudinal frames, a few inches in front of the
> radiator.
an oil cooler on a Bugeye will not fit when the bonnet closes.You have to mount
it on the side of the radiator support long ways.
At least I had too, maybe other listers have other ideas.
>
>
> 2. How do you clean out an oil cooler and tubing that has been opened up
> to grime and dust and spiders for some time? Solvent could stay in to some
> degree, and destroy oil properties. Water a similar concern. Oil does not
> flow when cold enough to pass through easily.
Kerosene or diesel fuel works well for this.
--
Frank Clarici Toms River, NJ
Too many LBCs
3 Sprites, an Austin A40, and an Austin Mini all on the road.
1 Jaguar XJ6 family car, 1 Racer Midget project , & 2 Parts Spridgets
Check out my home page at http://www.exit109.com/~spritenut
--------------------------------------------------------------------------------------------
|