| To: | chuckc@ibm.net, jphender@inav.net |
|---|---|
| Subject: | Re: Homebrew Eezibleed (long) |
| From: | P Van Wig <PVanWig@aol.com> |
| Date: | Mon, 12 Jan 1998 09:25:39 EST |
| Cc: | kpatton@worldnet.att.net, spridgets@Autox.Team.Net |
| Organization: | AOL (http://www.aol.com) |
| Reply-to: | P Van Wig <PVanWig@aol.com> |
| Sender: | owner-spridgets@Autox.Team.Net |
In a message dated 98-01-11 13:06:27 EST, chuckc@ibm.net writes: << I have not been following this thread, but if you are talking about a cap for the clutch master cylinder so you don't cannabalize the original, when I did mine, I found that the threaded plastic cap from a quart oil bottle worked great. And I was able to seal the needle (after roughing up the shank) into the cap to prevent air loss. Someone else found that the needle would fit the pre-drilled metal cap already on the MC. chuck -- >> Try the metal cap from a brake fluid can. Its what I used on my 65 Sprite. Paul Van Wig Long Beach, CA 60 Bugeye 60 Minor Woody 61 Minor Pickup |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: '73 Midget. Was: Mini Vs. Midget 1275 blocks, Richard L. Bergstrom |
|---|---|
| Next by Date: | NYS Emissions, Nory |
| Previous by Thread: | Re: Homebrew Eezibleed (long), Christopher T Palmer |
| Next by Thread: | speed bleeders torque, Jeff Boatright |
| Indexes: | [Date] [Thread] [Top] [All Lists] |