Hi All,
Several people have suggested Helicoils, which I mus confess I did not
think of.
The engine front plate is only about .160 inches thick, whereas the
helicoil is about .320 inches deep.
Would the depth difference cause a problem?
Thanks,
Roger Elliott
On 12/16/2012 03:31 PM, Bill Gingerich wrote:
> I think I put a helicoil in the block on mine.
> BillG
>
> -----Original Message-----
> From: spitfires-bounces@autox.team.net
> [mailto:spitfires-bounces@autox.team.net] On Behalf Of Roger Elliott
> Sent: Sunday, December 16, 2012 2:18 PM
> To: Spitfire list
> Subject: [Spits] Top Timing cover Screw
>
> Hi All,
>
>
> I am putting my engine back together. One of the screws at the top timing
> cover, is held in by the the front engine plate being threaded.
> Right behind that screw is the mounting bracket for the alternator.
>
> Well, the threads in the engine plate are to stripped to hold the screw, and
> I can't put a nut on the backside of the plate as the bracket does not allow
> room for one.
>
> Has anyone else run into this problem? Did you find a solution?
>
> I have thought about using JB Weld, but I am not sure it is the best
> solution.
>
> Thanks,
> Roger Elliott
> 80 Spitfire
> _______________________________________________
>
> Spitfires@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $11.47
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/spitfires/wrgingerich@gmail.com
_______________________________________________
Spitfires@autox.team.net
Archive: http://www.team.net/archive
|