spitfires
[Top] [All Lists]

[Spits] GT6 gearbox query

Subject: [Spits] GT6 gearbox query
From: jimmuller at rcn.com (Jim Muller)
Date: Sun, 02 Jan 2011 16:27:46 -0500
I've put an exploded diagram up on my website so I'll refer to it:

http://users.rcn.com/jimmuller/pics/exploded_gearbox.jpg

I have a minor problemm at the front end of the mainshaft.  At the 
front end of the shaft the 3rd gear #7 is locked on with a recessed 
collar #6 and a thick snap ring #5 that snaps into a notch in the 
shaft.  The notch is actually in the splines on the end of the shaft 
and not shown in the diagram.

In the past I've never had trouble here even though the snap ring is 
a tight fit, but now I can't get it to snap into place.  The thing 
is, I can't see any way to gain any more space.  The position is 
fixed at the rear by the split thrust washer #15 which fits into the 
forward-most groove in the shaft (just to the right of ID #29).  All 
the space between there and the washer #5 is taken up with bearing 
sleeves #8 and #10 and thrust washers #9 and #13.  (Actually my box 
has the "upgrade" part #11 from the Spitfire 3-rail box in place of 
#9 and #10, but the effect is the same.)  As near as I can figure, 
the snap ring must be deformed enough to prevent it from dropping 
into place.

So does this sound like a reasonable explanation?

I guess I should get new spit washers and a new snap ring anyway.  It 
will mean a $2 order from Spitbits when they have a minimum order of 
$10.  Plus I'll have to way for the mail...

Thanks!


-- 
Jim Muller
jimmuller at rcn.com
'80 Spitfire, '70 GT6+

<Prev in Thread] Current Thread [Next in Thread>