In the installation procedure for the Ford Type-9 transmission, I'm about to
install the clutch release bearing. The question is, which way does it go?
I expect that the flat side of the bearing faces rearward, and the rounded
side faces the clutch "fingers". However, it is not clear when referring to
a VB catalog or the Haynes manual. Does anyone have experience here?
Dan Parrott
Savannah, Ga
1980 Triumph Spitfire "PJ"
1973/1978 Spit Six Project car "Joseph"
1957 Chevy Bel Air "Mayflower"
_______________________________________________
Spitfires@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|