I should have mentioned that I have a 1972 GT6 MKIII with a rotor flex rear
axle. I can get the hub off, but the axle seems hard to turn, due to maybe
not enough end float with the end nut.
Dan Parrott
Savannah, Ga
1980 Triumph Spitfire "PJ"
1972/1978 Spit Six Project car "Joseph"
-----Original Message-----
From: Jim Cullen [mailto:ccullen16@cogeco.ca]
Sent: Sunday, January 17, 2010 7:03 PM
To: Daniel Parrott
Subject: Re: [Spits] GT6 Rear Hub Bearings
Not sure if this is exactly the type of thing your looking for, but this
video was helpful when I did my rear hubs this past summer.
http://www.youtube.com/watch?v=Qvbi1UZpHPI
Jim Cullen
----- Original Message -----
From: "Daniel Parrott" <parrotthead01@comcast.net>
To: "'Spitfire list'" <spitfires@autox.team.net>
Sent: Sunday, January 17, 2010 2:31 PM
Subject: [Spits] GT6 Rear Hub Bearings
> Does anyone have access to a reference to set of step-by-step directions
> for
> the replacement of the rear hub bearings, hubs and axels for a 1972 GT6?
> I
> need guidance to make sure that the bearings are seated with the proper
> end
> float.
>
>
>
> TIA
>
>
>
> Dan Parrott
>
> Savannah, Ga
>
> 1980 Triumph Spitfire "PJ"
>
> 1972/1978 Spit Six Project car "Joseph"
>
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> Suggested annual donation $11.47
>
> You are subscribed as ccullen16@cogeco.ca
>
> Spitfires@autox.team.net
> http://autox.team.net/mailman/listinfo/spitfires
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $11.47
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|