I found one at Canley Classics
(http://www.canleyclassics.com/products.asp?article=hubpuller.xml).
I purchased one when the dollar/pound exchange rate was pretty good. Well
made example, not bad for the price.
Dan Parrott
Savannah, Ga
1980 Triumph Spitfire "PJ"
1972/1978 Spit Six Project car "Joseph"
-----Original Message-----
From: spitfires-bounces@autox.team.net
[mailto:spitfires-bounces@autox.team.net] On Behalf Of Mark Sinclair
Sent: Tuesday, July 28, 2009 4:39 PM
To: spitfires@autox.team.net
Subject: [Spits] Rear Axle Puller
Hello all:
I'm replacing some rear axles seals, starting with the inner axles
assemblies. I believe I need the same Churchill Tool, the puller, for
the inner and outer axles. Can anyone confirm this?
Also, does anyone is there a source these days for the rear axle puller,
a replica for the Churchill Tool?
Failing that, does anyone know someone in the San Francisco Bay Area who
has done these.
Thanks
Mark Sinclair
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|