Hi Daniel,
The inner rocker panel (sill) has a flat bottom to it and is welded to the
floor. The centre rocker panel's (membrane) bottom edge is welded to the
floor's turned down edge.
I just did this last year and have a few pictures of this area if you are
interested.
Mark
Subject: [Spits] Floor Pan replacement
Further inspection shows that the replacement pan outside edge is straight
from front to back and there is a turned down edge. I appears that the
Inner Rocker Panel is getting in the way. My inner and outer rocker panels
appear to be ok and will not need replacement (at far as I can tell). So
the question is, do I have to remove the Inner Rocker Panel to get to the
floor pans, or can I (or should I) cut the old floor along the Inner Rocker
Panel and bend the replacement floor panel upward to be tack-welded to the
Inner Rocker Panel?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|