Same as for the lower wishbone :-)
I have always used a puller made from a long bolt and a
bunch of various-sized washers, and the bushings always went
in OK.
Is the hole where the bushing goes reasonably clean and
smooth?
Instead of grease, it would be better to use a water based
lubricant.
You want something that will eventually wash away so the
rubber bushing will not permanently slide in the hole. Your
local pharmacy will have something suitable :-)
Alternatively, dish soap (or "washing up liquid"as
they say in Britain) should work well.
Doug Braun
'72 Spit
--- On Sun, 2/15/09, Rob T. Getzinger
<RTGetzinger@scif.com> wrote:
> From: Rob T. Getzinger <RTGetzinger@scif.com>
> Subject: [Spits] Upper wishbone bush install
> To: "Spitfire list"
<spitfires@autox.team.net>
> Date: Sunday, February 15, 2009, 7:11 PM
> What is the method to install stock bushings back into the upper wishbone?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|