spitfires
[Top] [All Lists]

Re: [Spits] Strange noise after swapping out transmissions

To: "Spitfires" <spitfires@autox.team.net>, "OKCSpitfire"
Subject: Re: [Spits] Strange noise after swapping out transmissions
From: "Luke Lewis" <superluke@execulink.com>
Date: Mon, 28 Jan 2008 08:53:45 -0500
--===============1201896571==
Content-Type: text/plain; format=flowed; charset="windows-1250";
        reply-type=original
Content-Transfer-Encoding: 7bit

I had a similar sound from mine after changing tranny mounts, it was the 
corner of the driveshaft arch (Which I had obviously leaned on a little 
during tranny swaps) touching the driveshaft.

Luke
Parkhill, ON

----- Original Message ----- 
From: "OKCSpitfire" <OKCSpitfire@sbcglobal.net>
To: <spitfires@autox.team.net>; <triumphs@autox.team.net>
Sent: Sunday, January 27, 2008 10:16 PM
Subject: [Spits] Strange noise after swapping out transmissions


> Hello listers, Once again looking for a little advice. I took the complete
> drive train from a 77 Spitfire and placed it in my 76 Spitfire. Installed 
> a
> new clutch, pressure plate an throwout bearing. Rebuilt the clutch master
> and slave cylinders. The trans is complete with a j-type overdrive. After
> completing the job, got the wiring correct thank to the LBC guru's from 
> the
> forum. The problem is this strange noise when I come to a stop. The car 
> was
> a daily driver before the swap and did not make this noise. The noise is
> like a small screw or metal object has fallen into the brake rotor. I
> noticed it on my first test drive following the swap but my initial 
> thought
> was the throwout bearing was defective so I pulled the trans again and
> replaced the bearing. I used a clutch alignment tool to check the 
> alignment
> and it was good. I replaced the bearing and put the trans back in the car
> took it for another spin and the same sound was there, secon thought was 
> the
> finger on the pressure plate but then if the clutch is properly aligned it
> should be ok. I looked at my rotors anddid not see any foreign material
> lodged in the calipers or anywhere else. This is very puzzling and if 
> anyone
> has run across this or has any suggestions I would greatly appreciate any
> input.
>
> Thanks
> Jerry Stasyszen
> OKCSpitfire@sbcglobal.net
>
> Version: 7.5.516 / Virus Database: 269.19.8/1235 - Release Date: 1/21/2008
> 9:39 AM
>


--------------------------------------------------------------------------------


> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> Spitfires@autox.team.net
> http://autox.team.net/mailman/listinfo/spitfires
>
> http://www.team.net/archive
>


--------------------------------------------------------------------------------


No virus found in this incoming message.
Version: 7.5.516 / Virus Database: 269.19.11/1244 - Release Date: 25/01/2008 
7:44 PM

--===============1201896571==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline

_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires

http://www.team.net/archive

--===============1201896571==--

<Prev in Thread] Current Thread [Next in Thread>