Funny timing, I sent the message below to the NASS list earlier today. Based
on the look of the nut that came off and what I've read, some folks use a
hammer and cold chisel to loosen it. Hope that helps.
Nick Moseley
-----Original Message-----
From: Nick Moseley [mailto:nmoseley@dccnet.com]
Sent: Monday, January 07, 2008 11:41 AM
To: 'nass@yahoogroups.com'
Subject: RE: >>NASS Re: Was Carbs -Valve timing- now crank nut tools
I'm rebuilding an engine and needed to remove the crank nut.
The 1 13/16ths socket was only 9.99, but the adapter from 3/4 to 1 in was
12.99. www.princessauto.com Pages 281 and 283 from their 8000 page catalogue
Nick M #278
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Spitfires@autox.team.net
http://autox.team.net/mailman/listinfo/spitfires
http://www.team.net/archive
|