That's exactly what I did... 30+ years ago.
Still there...
Clark
-----Original Message-----
Jim,
This is easy, get a bolt from your local hardware store that is long enough
that it has +/- 2" of unthreaded shaft and is the correct size to fit in the
hole. I think the shaft is 1/4" or 3/8". Drop this in from the top and
then for additional safety thread a nyloc nut onto the end. The nut does
not need to be completely tightened down. This will serve as a new pin and
will not fall out in the future.
Bob Berger
78 Spitfire
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|