Andy
The brackets that hold the visor are an "L" shape. The long end of the
"L" goes into the visor.It is about four inches long and has a slight bend
in it to make it so it will stay where you put it once it is installed. They
may be rusted in there. There is two for each visor.
----- Original Message -----
From: "Andrew Lindeman" <andrew.lindeman@gmail.com>
To: <spitfires@autox.team.net>
Sent: Monday, August 21, 2006 9:37 PM
Subject: Sun visors
>I bought some new sun visors and can't figure out how to instal them. They
> came without the rods that come out at both ends. I thought it's just be
> a
> long bar I'd shove through the new visors, but it's not. I've taken all
> the
> foam and vinyl off the old visors. I can see where it enters a tube
> that's
> connected to the wire support structure for the visor. I can twist the
> end
> that connects to windshield frame, but can't get it to slide out of the
> tube. Before I mangling my good hardware with undue force, I thought I'd
> ask the list if there is a trick to removing and installing the hardware.
>
> Andy L.
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.405 / Virus Database: 268.11.4/424 - Release Date: 8/21/2006
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|