In a word, YES. If you don't have the proper hub removal tool, you will
likely destroy the flange. But with the right tool it will be much easier
and faster.
Joe
----- Original Message -----
From: "Stasyszen, Jerry" <JStasyszen@odmhsas.org>
To: <nass@yahoogroups.com>; <Spitfires@autox.team.net>;
<triumphs@autox.team.net>
Sent: Thursday, June 15, 2006 11:29 AM
Subject: [TR] Wheel bearing problem
> I have a new little dilemma here, I an replacing the rear wheel
> bearings on the rear end. Is this very difficult? I have replaced front
> and rear wheel bearings on US cars but not on a Spitfire, I will also be
> replacing the U-Joints at the same time.
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|